EXT SUPERLIGHT V2 – Lightweight Steel Spring for Rear Shocks
EXT SUPERLIGHT V2 is the second generation of lightweight steel springs developed by Italian manufacturer EXTREME SHOX, designed for rear shocks on enduro and downhill mountain bikes. It was developed using special materials and manufacturing processes derived from the manufacturer’s experience in automotive motorsport.
The main development objective was to reduce spring weight while maintaining high mechanical strength, linear spring characteristics, and resistance to long-term dynamic loads.
Compared to the previous Superlight generation and conventional steel springs, the new generation offers up to 30% lower weight, depending on the selected spring rate and length.
Special Steel Alloy with Higher Vanadium Content
EXT SUPERLIGHT V2 uses a specially developed steel alloy with a higher vanadium content, also used in demanding motorsport applications.
The material has high tensile strength and a high modulus of elasticity, allowing it to withstand significant repeated loads.
The combination of material, optimized geometry, and special manufacturing processes allows the production of a lighter spring without the need for titanium.
Up to 30% Lower Weight
By optimizing the material and geometry, EXT has achieved a weight reduction of up to 30% compared to conventional steel springs and the previous Superlight generation.
The actual weight reduction depends on the spring rate and the required shock stroke.
Each spring is designed with the minimum necessary length that still allows the full intended shock stroke to be used. This reduces the amount of material required and consequently the overall spring weight.
Linear Spring Characteristics
EXT SUPERLIGHT V2 is designed with highly linear spring characteristics, meaning that spring force increases consistently as compression increases.
This provides a predictable rear suspension response and allows more precise adjustment of the shock’s hydraulic settings.
The spring rate can be selected according to rider weight, rear suspension leverage ratio, and the bike’s intended use.
Precise Spring Rate Selection
EXT offers springs with various spring rates, with many versions available in 25 lbs/in increments.
Smaller increments between spring rates allow more precise suspension SAG adjustment and selection of the appropriate spring according to rider weight and rear suspension characteristics.
Two basic lengths are available:
- C65: for shocks with a stroke of up to 65 mm.
- C75: for shocks with a stroke of up to 75 mm.
Available spring rates depend on the selected spring version.
Long Service Life
During the development of SUPERLIGHT V2 springs, EXT applied standards and experience from the automotive industry.
The springs are designed for more than 500,000 load cycles, while the special steel alloy provides high resistance to material fatigue.
The spring surface is protected by a hard epoxy coating, which helps protect against external influences.
Spring Preload
EXT SUPERLIGHT V2 is designed not to require additional preload.
The manufacturer permits a maximum of 2 mm preload, making it important to select the correct spring rate according to the rider and rear suspension system.
If the spring requires more preload to achieve the correct SAG, the selected spring rate should be reviewed.
Rear Shock Compatibility
EXT SUPERLIGHT V2 springs have an inner diameter of 38.5 mm.
With the use of appropriate spacers or adapters, they can also be installed on rear shocks from other manufacturers.
Before installation, the inner diameter, spring length, available clearance, and maximum shock stroke must be checked.
For springs with a rate above 600 lbs/in, EXT requires the use of a reinforced spring retainer on compatible shock models. These springs are not permitted on certain older EXT models.
We recommend checking compatibility and selecting the correct spring with VETTA Trade before ordering.






